Main > Main Forum

Any interest in original cab dimensions

Pages: << < (23/69) > >>

mmmPeanutButter:


--- Quote from: menace on November 19, 2003, 03:52:20 pm ---nobody has asked about burgertime ( and i was hoping no one would-- i have no ide a how to measure peter's hat :-[ ???)  But i will give it a try--I'm going to my brother's this friday so i will get more tempest measurements and take a stab at burgertime for ya.

--- End quote ---

I like to be as difficult as possible...  I don't know where you are located, but if you can get a good tracing and (snail) mail it to me, I can put it into autocad accurately for the plans.  As long as there is some reference to where the tracing begins (like the paper was held horizontally xx inches from the bottom of the cab and then traced - this way it can be done correctly)

I guess this request goes out to anyone who had a burgertime cab.  I'd prefer if Jacobud would do the bulk of the drawing - but I could take care of the hat part - if I can get the tracing supplied.  Just drop me a message if there are any takers.

Thanks.

eightbit:


--- Quote from: menace on November 19, 2003, 03:52:20 pm ---nobody has asked about burgertime ( and i was hoping no one would-- i have no ide a how to measure peter's hat :-[ ???)  But i will give it a try--I'm going to my brother's this friday so i will get more tempest measurements and take a stab at burgertime for ya.

--- End quote ---
If you have a digital camera and could get a straight on shot of it with a ruler or something to show the scale in the picture you should be able to accurately reproduce it.

dphirschler:

To get Burgurtime's rouded top, you could draw out a grid of 1"x1" squares on plexi.  Then photograph it over the cab.


Darryl

Jakobud:

This is what he needs to do to get the tracing correct.  Just take some sheets of graphpaper and hold them up behind the curved part.  Then take a picture of the side up close so you can see the graph paper.  This will allow me to create the curves in Autocad quite accurately with only a photograph.  The graph paper would be there just for reference so I can tell the curvature of the panel.

menace, what cabinets do you have access to at your brothers?  Try to get all the plans you can get if you are going there in a few days.

depressd:

I have plans for a pacman cocktail table. Anyone interested in me sending it. I found it posted on a cabinet site a while back. I assume it's not copyrighted or anything. The two files are in pdf format.

Pages: << < (23/69) > >>

Go to full version