Main > Main Forum
Any interest in original cab dimensions
<< < (21/69) > >>
Jakobud:
Yes I second that.  I actually have a DLII cabinet almost completely drawn up but there were a lot of missing dimensions from my source.... so I had to let it sit until I could find another one to measure and finish up the drawings.

If you could measure both of those cabinets that would be very good.  Just email me or PM me as soon as you can about it.
southpaw13:
Great thread going here...
Do you think that we will ever see the dimensions of a Cliff Hanger Cab?   Thanks
Jakobud:
Perhaps.... that is if someone has access to one and was willing to send me dimensions for it.  I would totally draw it up.  This project relies a lot of people willing to take the time to take a few measurements and send them to me... but its harder to convince people to do that than you would think :)  I've sent messages to lots of people on this board who own original cabinets and they almost all have the same response "sure i'll measure it for you when i get around to it".... which appears to be never :)  Only a few people (you know who you are...thank you) have hooked me up :)  So to sum up, if anyone has a Cliff Hanger cabinet or has access to one I would draw it up immediately if they could send me the info.
southpaw13:
Here are the only measurements that I have collected over the years for a Cliff Hanger Cab.
Marquee  22-7/8 x 6-3/4  in
CONTROL PANEL 22-7/8 x 7-3/4  in
Cabinet height 179 cm
Width of the side 81 cm

I'm not sure any of this will help, but it's a start!!!!
Jakobud:
Yeah thats a start..... but there is a lot more to it than that...
Navigation
Message Index
Next page
Previous page

Go to full version