| Main > Main Forum |
| Please critique my control layout before I start drilling. |
| << < (3/4) > >> |
| upper2bits:
--- Quote from: jimmy2x2x on August 01, 2011, 06:17:20 pm ---Is the CP so wide to accommodate the cab, or will the CP overhang the cab? --- End quote --- What the full cab looks like: |
| upper2bits:
Playing around with some graphics. :-) |
| eds1275:
--- Quote from: fallacy on August 01, 2011, 02:51:19 am ---id say Heineken suck. >:D --- End quote --- Heineken is my friend! |
| Gray_Area:
It looks fine....though the following is running in my mind: you had the ability to make nice curves, yet didn't make the front 'corners' rounded. At least round the edges off. Thread title: "...before I start cutting..." |
| upper2bits:
--- Quote from: Gray_Area on August 03, 2011, 04:33:14 pm ---It looks fine....though the following is running in my mind: you had the ability to make nice curves, yet didn't make the front 'corners' rounded. At least round the edges off. Thread title: "...before I start cutting..." --- End quote --- I tried it with rounded corners but it looked odd to me. |
| Navigation |
| Message Index |
| Next page |
| Previous page |