| Main > Main Forum |
| U360 Maintenance |
| << < (2/2) |
| syph007:
--- Quote from: drventure on July 29, 2011, 06:15:03 pm ---At one point, I thought Andy had said not to use any grease/oil on the u360's, but then if I recall, there was a mention that they were going to start. I was having similar problems with mine. I disassembled them and puffed a generous amount of graphite (a dry power lube used in clocks a lot) in there (between bearing on the shaft and the plastic part of the base that it rests in) and that seems to be working quite well. Plus it can't gum up (which is why it's used in clocks). --- End quote --- It was silicon grease that Andy recommends. |
| Navigation |
| Message Index |
| Previous page |