Arcade Collecting > Pinball

Request: Help with Bally Harlem Globetrotters (Resolved)

<< < (3/3)

TopJimmyCooks:
Thanks to the help of these two fine gents :applaud: and a whole lotta multimetering, I got everything working!

*Figured out the playfield controlled lights were all out due to the F1 fuse-burned out. Replaced it and they all worked.
*replaced a bunch of weak or burned out lamps.
*traced the nonworking GI lights back to the connector on the Rectifier board - jiggled the connector until it worked
*cleaned all the major crap off the playfield.

Next up:
*Drink beer.  Play pinball.
*replace connectors and header pins on rectifier board - they are baked.
*work on a few lights/sockets/scrs that are still a little flaky. 
*proper playfield cleaning and rubber replacement
*get the coin mech's working better

Long term:
*replacing some components and cleaning corrosion on the old MPU to try to get it working.  (then sell alltek board for $$$$$$$)
*flatten playfield plastics
*level the playfield inserts and maybe touch up around them. 

Good night and good luck.

Navigation

[0] Message Index

[*] Previous page