Main > Main Forum
PCB mounting feet (need like 20 sets of 4)
<< < (3/3)
runawayabc123:
Ok, I got the tubing and a bunch of screws/nuts for about 12 boards for $5. 

What kind of screws did you get?  I couldn't find any plastic washers... so I will have to make those too. 

Also, how are you cuting the tubing?  Side cutters?  How badly does it crush? 

Thanks! 

The greed of the pcb feet people have lost out today.   :applaud:
syph007:
I just used a very sharp knife to cut the tube.  I used nylon washers on top, which home depot had.  Really though you could just cut a small piece of tube for a washer.  Then just find some screws with a large flat head and you're good to go.
milkit:
i have a ton, $.90 per set of 4
Navigation
Message Index
Previous page

Go to full version