| Main > Main Forum |
| U360 Wiring Harness in Output Mode- Not working any Advice? |
| (1/1) |
| Charles4400:
Hi All, I have 4 x U360s on my panel and just put 4 wiring harnesses on them in output mode to attach to my ipac. 2 of them work and 2 do not recognize the wiring harness at all. All sticks work in analog mode. But in 'switch mode' I get nothing from 2 of them. It's not the harness as I switched the bad boards harness with known working harnesses and there was still no output. I also put the harness from the 2 bad boards on known working boards and they did output properly. So harnesses should be fine. I also tried the boards in 5v mode without the USB and stil got no output. Has anyone experienced this or is this just a case of haveing bad boards sent in 2 of the sticks? I contacted Andy but think he still on vacation...so was just wondering if anyone here experienced this and had a fix? Thanks, Charles |
| syph007:
Do all the sticks have the same firmware? |
| Navigation |
| Message Index |