Main > Main Forum
Volume control knob for PC Speakers
<< < (2/4) > >>
Vigo:
A bit spendier, and you would have to get adaptors from 6.3 down to 3.5, but here is one with a genuine knob. Unfortunately, the knob is right on the jack instead of on the line. It might make mounting a bit difficult.

http://www.sweetwater.com/store/detail/VCable250-10?utm_source=CSE&utm_medium=PPC&utm_campaign=none&utm_term=VCable250-10-V-Cable_250k_10&SID=0&zmam=89202644&zmas=1&zmac=1&zmap=VCable250-10


Edit: Actually now thinking about it, a guitar cable would only be mono. Nevermind. :-\
scofthe7seas:
I wonder if you can take off that knob and put another longer stemmed one on.
syph007:

--- Quote from: emb on July 06, 2011, 12:52:19 pm ---
--- Quote from: syph007 on July 06, 2011, 12:45:03 pm ---replied in your delere me thread, before i noticed it was in wrong forum.

Reposted here

This post helped me make one.  I just bought the pot and a 3.5 extension, and located the pot in the middle, then found a shiny knob.

http://scarvell.net/wiki/index.php?title=VOLUME_CONTROL_MOUNTING_AND_WIRING

--- End quote ---

Thanks for that link, although I am looking for a pre-built solution. If there isn't one, I can solder one up.

--- End quote ---

I tried to find one just as you are describing and never could so I had to make one.  You really want a panel mount pot anyway, and I doubt that exists prefabbed, or at least I wasn't able to find.  It was very easy to make even for me :D
emb:

--- Quote from: syph007 on July 06, 2011, 01:52:31 pm ---
--- Quote from: emb on July 06, 2011, 12:52:19 pm ---
--- Quote from: syph007 on July 06, 2011, 12:45:03 pm ---replied in your delere me thread, before i noticed it was in wrong forum.

Reposted here

This post helped me make one.  I just bought the pot and a 3.5 extension, and located the pot in the middle, then found a shiny knob.

http://scarvell.net/wiki/index.php?title=VOLUME_CONTROL_MOUNTING_AND_WIRING

--- End quote ---

Thanks for that link, although I am looking for a pre-built solution. If there isn't one, I can solder one up.

--- End quote ---

I tried to find one just as you are describing and never could so I had to make one.  You really want a panel mount pot anyway, and I doubt that exists prefabbed, or at least I wasn't able to find.  It was very easy to make even for me :D

--- End quote ---
I am an electrical computer engineer and have pots lying all over the place from back in college. I don't mind soldering one up, I just figured it would save me a little time to order one.
emb:
Yea, I think I will just solder one up. Thanks for everyones help.
Navigation
Message Index
Next page
Previous page

Go to full version