Main > Main Forum

Spinner Design Question

Pages: << < (3/3)

PL1:


--- Quote from: D_Harris on June 24, 2014, 07:31:15 pm ---I did some searching and assume that this is the place to get the controller. http://northamerica.emukade.com/product-category/encoders/

And that what I need is one of the following, correct?:

1) "DIY KADE miniArcade kit complete"
2) "DIY KADE miniArcade kit no AVR"
3) "KADE miniArcade- Red, White, and Blue"

--- End quote ---
Options 1 and 3 have the required "brain", a Minimus AVR -- either an at90usb162 or an atmega32u2 will work with all the miniArcade series of firmwares.

There are also other places like here to get a Minimus AVR if your budget is tight.


--- Quote from: D_Harris on June 24, 2014, 07:31:15 pm ---I'm just not sure where to get the "new KADE miniArcade firmware" you mentioned.

I can solder, but not much more than that. Anything involving software requires step-by-step instructions, which I've found to be rare.

--- End quote ---
The firmwares are in the Loader software.

The instructions are spelled out in the QuickStart guide here and in the KADE Loader software.   ;D


Scott

D_Harris:

I probably should have bought more MiniPACs when they were $29. (Not including harness).  ;D

The MiniPAC is simpler/easier to install. At the time I considered them overkill for the kind of control panel I mentioned above and decided to save them for a different project.

Thanks.

Darren Harris
Staten Island< New York.

Pages: << < (3/3)

Go to full version