| Main > Main Forum |
| Spinner Design Question |
| << < (3/3) |
| PL1:
--- Quote from: D_Harris on June 24, 2014, 07:31:15 pm ---I did some searching and assume that this is the place to get the controller. http://northamerica.emukade.com/product-category/encoders/ And that what I need is one of the following, correct?: 1) "DIY KADE miniArcade kit complete" 2) "DIY KADE miniArcade kit no AVR" 3) "KADE miniArcade- Red, White, and Blue" --- End quote --- Options 1 and 3 have the required "brain", a Minimus AVR -- either an at90usb162 or an atmega32u2 will work with all the miniArcade series of firmwares. There are also other places like here to get a Minimus AVR if your budget is tight. --- Quote from: D_Harris on June 24, 2014, 07:31:15 pm ---I'm just not sure where to get the "new KADE miniArcade firmware" you mentioned. I can solder, but not much more than that. Anything involving software requires step-by-step instructions, which I've found to be rare. --- End quote --- The firmwares are in the Loader software. The instructions are spelled out in the QuickStart guide here and in the KADE Loader software. ;D Scott |
| D_Harris:
I probably should have bought more MiniPACs when they were $29. (Not including harness). ;D The MiniPAC is simpler/easier to install. At the time I considered them overkill for the kind of control panel I mentioned above and decided to save them for a different project. Thanks. Darren Harris Staten Island< New York. |
| Navigation |
| Message Index |
| Previous page |