Main > Main Forum
Custom Monitor Bezel
(1/1)
Woodshop Flunky:
I'm going to go way out here...

Does anyone have any experience with vacuum forming?  I have several sheets of ABS plastic with haircell texture on one side.  I would like to produce a monitor bezel for the CRT PC monitor I decased.

I've read about it, and I have a process in my head that I think will work.  However, it certainly seems like a LOT to bite off.

Anyone tackle something like this before?
mrclean:
phineas foo on the KLOV forums does this : http://forums.arcade-museum.com/showthread.php?t=151068, I would contact him.
HaRuMaN:
Or you could just do this:

2 dolla bezel
Woodshop Flunky:

--- Quote from: mrclean on June 23, 2011, 02:46:35 pm ---phineas foo on the KLOV forums does this : http://forums.arcade-museum.com/showthread.php?t=151068, I would contact him.

--- End quote ---
I think I've run across this guy before, but at this point in my build, I don't think I can justify the expense (if I can do something myself).


--- Quote from: HarumaN on June 23, 2011, 02:48:51 pm ---Or you could just do this:

2 dolla bezel

--- End quote ---
Thanks.  If the ABS doesn't pan out... I'll likely end up with something like this. :)
Navigation
Message Index

Go to full version