(I have yet to upgrade my u360 firmware or install the mala ultrastick mapper plugin, but I don't think that's the problem)
When I first installed a u360, it was working great, then when I restarted, it didn't work, but the buttons did. Then in UltraMap I assigned its ID to #2 and installed a second u360 as #1. At some point in re programming, it worked again (I think I set it to 4-way or something, then back to analog). So both sticks were working and life was good. On the next startup, same problem. Now I'm sure these bad boys are meant to work on startup, is there something I'm doing wrong? I'm unable to coax any activity out of them in UltraMap, the joys are unresponsive in the preview-calibration window. I'm not using any USB extension wires or anything. help?