| Main > Main Forum |
| Looking for Input on Control Panel Layout |
| (1/5) > >> |
| Indyplumber:
Well, my cabinet is almost done as far as woodworking is concerned. Now I just need to complete the control panel top. I've made a template from cardboard to make it easier on me. I have played with the buttons and I'm pretty happy with where they are but it's the placement of the joysticks that have me puzzled. It's a pretty common mini-frank panel with 2 8-ways, a 4-way, a spinner and trackball. I've gone with 2" center to center spacing for buttons and kept 8-ways 3.75" center to center from buttons. Anyway, here are some layouts I've played with. I'm concerned with 2 things: #1 - will anything be in the way of the trackball? #2 - will it be awkward to use the spinner or 4-way? Exhibit A: 8-ways toward the center and 4-way/spinner toward edges Exhibit B: Left 8-way has moved to the edge. Exhibit C: Left handed 8-ways again, but Spinner and 4-way moved toward center. (i worry about the spinner here) Exhibit D: 4-way and spinner still center and both 8-ways to edges (just wonder if right 8-way will be awkward feeling even though this gives a lot of access) Exhibit E: Same as D but Trackball moved 1" up toward center. Feedback and advice is welcome. And the $50 is what my dad just dropped by for my birthday. Gonna put it toward a coin door! :applaud: |
| Nephasth:
I think 2" centers on the buttons is a little too much. Give 1 1/2" centers a try and see if you like that (I used 35mm centers which is a little less than 1 1/2"). I would go with Option C, but I would rotate the 4-way 90 degrees and place the spinner near (but not too close) to the bottom right corner of the 4-way. But in the end, go with what feels best to you. |
| mgb:
I would say C. I definately wouldn't go a route that put the 6 button configurations to the left of the 8-ways like A,D or E. you want to make sure that you can comfortably reach the spinner without having a joystick in the way. I assume your concern for the track ball clearance is for Golden Tee. |
| Indyplumber:
--- Quote from: Nephasth on May 24, 2011, 10:39:33 pm ---I think 2" centers on the buttons is a little too much. Give 1 1/2" centers a try and see if you like that (I used 35mm centers which is a little less than 1 1/2") --- End quote --- I was wondering about that too. I'm gonna try placing them 1.4 to 1.5 inches apart and see how that affects the Joysticks. Maybe open up the center some more. --- Quote from: mgb on May 24, 2011, 10:44:51 pm --- you want to make sure that you can comfortably reach the spinner without having a joystick in the way. I assume your concern for the track ball clearance is for Golden Tee. --- End quote --- Yes, golden tee. I'm gonna change the button spacing and see if the right Joystick moving to the right helps with the spinner placement. |
| Nephasth:
It might not be too bad to move the two buttons near the 4-way to the right and place the spinner between them and the 4-way. |
| Navigation |
| Message Index |
| Next page |