| Main > Main Forum |
| Ok Baby candy cab CPS2 question (about stereo sound) |
| << < (2/3) > >> |
| Malenko:
--- Quote from: amendonz on May 13, 2011, 12:58:54 am ---hmm.not sure i follow, i am using the jamma connector now, but its only running on one speaker, i'd rather be running stereo from the A board, but when i plug it in nothing changes... the non working speaker isn't broken, its just not receiving any signal, also the cps2 board is outputting stereo, i checked on my stereo. so are you saying what i have it plugged into is not an amp then? (The cps2 audio output via rca cables) so i have to find a switch to change it from mono to stereo? hmm.. my friend was saying some ok baby have a switch next to the volume control for that, in mine its just a covered hole. :timebomb: looking more likely shes going full time mono... --- End quote --- How are you hooking the A board into your stereo? Jamma is mono. if you use the RCA outs from the A board, you feed them into an amplifier and then use that to power the speakers. |
| amendonz:
@emphatic, so, from that manual, i need to pull off the wires from the mono output and move them onto the stereo amp output? ok, seems not too hard... |
| emphatic:
--- Quote from: amendonz on May 14, 2011, 06:47:18 pm ---@emphatic, so, from that manual, i need to pull off the wires from the mono output and move them onto the stereo amp output? ok, seems not too hard... --- End quote --- If possible, take a picture of your amplifier and it will be easier to help you. |
| amendonz:
best photo i could take, hope its not too fuzzy. |
| amendonz:
thats with the stereo rca not connected (obviously) |
| Navigation |
| Message Index |
| Next page |
| Previous page |