Main > Main Forum
Speaker Holes?
eds1275:
--- Quote from: vast on April 27, 2011, 04:01:27 pm ---I'm popping in 4" speakers. I'd love to use a circle jig but it cost is prohibitive (especially when I only have a loaner router).
Just ordered a set of hole saws from amazon that has a 4" hole saw, it was only £11. Hopefully it will do the job! I shall definitely be rounding over the edges :cheers:
--- End quote ---
Don't forget to go halfway through both sides or you'll have some nasty tearout on the exit side.
jmohr1:
--- Quote from: eds1275 ---Don't forget to go halfway through both sides or you'll have some nasty tearout on the exit side.
--- End quote ---
Would you think clamping a piece of scrap to the back and just going partially into that be sufficient?
vast:
--- Quote from: jmohr1 on April 28, 2011, 12:47:37 pm ---
--- Quote from: eds1275
Don't forget to go halfway through both sides or you'll have some nasty tearout on the exit side.
[/quote ---
Would you think clamping a piece of scrap to the back and just going partially into that be sufficient?
--- End quote ---
I clamped scrap when i was doing my ventilation holes, they came out ok. I'll try the halfway on both sides trick on a dummy run first.
--- End quote ---
alfonzotan:
--- Quote from: gnateye on April 27, 2011, 02:12:18 pm ---a jigsaw and drill, then hide the ugly hole with a speaker grill
--- End quote ---
Ding-ding-ding. :applaud:
If you're going to use a grill anyway, who cares if a hole you can't see isn't perfect?
victorylane23:
a jigsaw and drill, then hide the ugly hole with a speaker grill :applaud:
Thats what i did and it looks really nice !!