| Main > Main Forum |
| Help With Analogs and LEDs |
| (1/2) > >> |
| Mrephunk:
Help With Analogs and LEDs Is there any way to get the analogs to work on an arcade stick? My reasons are that I have noticed a lot of the xbox arcade games require the analogs and not the dpad. If I make this cabinet I would want it to work with a couple other arcade games as well. Also, how hard is it to make the pushbuttons LED lit? I would be using a Xbox360 padhack, if someone could point me in the right direction it would be great |
| Donkbaca:
I know if you use madcatz sfiv pads, they have a switch that let's you have the dpad register as th dpad, the right analog stick, or the left analog stick. The sticks will be recognized as the left stick, but they will not be analog, they will just be on and off. As far as I know, there is no way to get a analog arcade stick to be compatible. As for LEDs, are you using a name pc? Or just the xbox? If its just the xbox you can use the 5v on the controller, but it's a constant 5v so he buttons would light even I the xbox is off |
| Mrephunk:
I was planning on just using the xbox, but I dont want the buttons lighted all the time. What would I have to do to get them to work properly?, Either on on pressing the, or just on when the power is going to it |
| Mrephunk:
anybody? |
| Donkbaca:
Okay, here is one way to do it, might not be the best. Get a 5v or 12v wal wart, and a smart strip. Plug the xbox into the main of the smart strip, the wall wart into one of the controlled sockets. Power the lights with the wall wart. The other way you can do it is if you desolder the SMDs on the controller and solder your lights to those, but that would be really, really hard, probably need a steady hand, good desoldering tool, super thin iron, and some 30 gauge wire. |
| Navigation |
| Message Index |
| Next page |