Main > Project Announcements
Miniature Arcade Project
shrunkenmaster:
Looking great my man, can't wait to see this fired up :applaud:
Corbo:
Finally finished the painting. It's very glossy but a lot of that will be covered by vinyl artwork, so it should balance out nicely when finished. Shown here with the speaker fitting clamped for the glue to set.
I really must take some pictures on something other than my phone the quality isn't great.
emphatic:
That looks great! :applaud:
Corbo:
Just the stickers and the plexi glass for the monitor, to go and maybe a little touching up from putting it back together again. All pictures taken on my phone, I'll bust out the digital camera tomorrow for some better shots.
Shown running Lion King on Sega Genesis.
Running Gauntlet arcade here (of course!)
The rear (including finger prints). Red button is power. This is the only fan present, there is no fan on the cpu heatsink. It's quite and cool inside.
Shown here with the hinged bottom half removed, and the screwed top half removed. Speaker is at the top, then monitor, halfway down on the left is the LED controller and on the right is the mini pac, then the PC itself is on a removable tray which isn't painted. Hard disk is underneath and all is mounted with rubber washers and sound proofing on the HD so it doesn't vibrate through the case.
A close up of the speaker. It clips on to the wood with a spring loaded clip that would normally attach the speaker to your laptop screen. I've added a couple of cable ties for good measure.
Looking in the back of the cabinet with the PC removed. Just the control panel in here.
Finally a couple of me putting it together.
Corbo:
OK I got the camera out, here are some better shots. Still waiting on the perspex (lightly smoked) for the monitor which is why you can see the 4 felt pads. There is some scuffing on the marquee but this will be covered with stickers.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version