| Main > Main Forum |
| jamma+ kick harness TMNT kanomi players3/4 |
| << < (2/6) > >> |
| runawayabc123:
--- Quote from: MonMotha on April 19, 2011, 10:04:55 pm ---The Molex 0.1" KK series should fit on to the PCB side connector just fine, and it's readily available. --- End quote --- Where would I find them at? I did some other searching and it looks like you can get the connector and contacts here: http://search.digikey.com/scripts/dksearch/dksus.dll?pname&WT.z_cid=ref_octopart_dkc_buynow&site=us&lang=en&name=455-2212-ND http://search.digikey.com/scripts/dksearch/dksus.dll?Detail&name=455-1135-1-ND But the connector is back ordered until 15-Jul-11. |
| MonMotha:
TMNT should have the JST "VH" series connectors on the PCB. These are next to impossible to find outside of Japan, but the Molex KK series will fit just fine. The connector you linked is the JST "XH" series, which isn't really compatible. Digi-Key should also have the KK series from Molex. I don't remember off-hand how many positions you need, otherwise I'd give you exact part numbers. Mouser should also have them, and Fry's Electronics stocks them in-store if you have one nearby. |
| runawayabc123:
--- Quote from: MonMotha on April 20, 2011, 10:50:02 pm ---TMNT should have the JST "VH" series connectors on the PCB. These are next to impossible to find outside of Japan, but the Molex KK series will fit just fine. The connector you linked is the JST "XH" series, which isn't really compatible. Digi-Key should also have the KK series from Molex. I don't remember off-hand how many positions you need, otherwise I'd give you exact part numbers. Mouser should also have them, and Fry's Electronics stocks them in-store if you have one nearby. --- End quote --- Are you sure about the VH series? I did a search and got that it has a 3.96mm pitch and only 11 pins (whereas I would need 15 to cover all of the pins). http://www.jst-mfg.com/product/detail_e.php?series=262 I know the one I listed clips in, but on my board there are no clips. So, not really right, but should work/fit. |
| MonMotha:
I'm sorry, I meant NH. That's a 2.5mm series. The Molex KK is 2.54mm (0.1"), but it's close enough, and mechanically very compatible. I don't think the XH connectors will even fit on the "blade" style pins used by NH series headers. |
| runawayabc123:
These: http://search.digikey.com/scripts/DkSearch/dksus.dll?vendor=0&keywords=H15P-SHF-AA-ND Lead time 11-Aug-11. :( MIN ORDER 200!!! (That is like 2 more than I need, rats. End sarcasm.) Group buy? I'd be willing to buy them if I could find enough interest to cover most of the cost. Figure $3each with contacts (1 connector and 15 contacts and I'll have to see if I can sneak it in snail mail for a stamp) and maybe enough interest for 40-50 of them or so. (Only puts me out around ~$50 total after all of the parts and 2 shipping directions and a bunch of parts in a box to save forever.) I'll have to noodle on this. |
| Navigation |
| Message Index |
| Next page |
| Previous page |