| Main > Main Forum |
| Wico reproduction shafts with 1.5" balltops! |
| << < (3/4) > >> |
| shilmover:
--- Quote from: armi0024 on May 12, 2011, 12:00:40 am ---I need to talk to Wolfeel about his plans. I will probably be doing hollow Wico shafts soon. However, on a VERY interesting side note. I took one of these ball tops and put it on a JLW Bat top shaft and it was 4 way heaven.... I know that JLW's are leafs, but it basically made a perfect Ms Pac/Galage replacement stick... I'll take pictures later. --- End quote --- Bryan, I really need one hollow shaft with a red ball (need to put a button in it), and a green ball. For my MultiVector. |
| mrclean:
--- Quote from: D_Harris on May 12, 2011, 06:51:16 am --- What do you use to clean yours? Darren Harris Staten Island, New York. --- End quote --- Hello fellow New Yorker! Simply put it in the end of your chuck of your drill.. and spin it, holding it with a magic eraser a dash of water or if it's really tough to get out use a sponge that has the green more abrasive backing (sorta like a light brillo pad) just hold it and spin / use your drill. Like this : |
| jasonbar:
--- Quote from: armi0024 on May 12, 2011, 12:00:40 am ---I need to talk to Wolfeel about his plans. I will probably be doing hollow Wico shafts soon. --- End quote --- Hey Bryan- See if you can lean on Wolfeel to sell just the threaded red balls--I'm dyin' for some!!! Thanks, -Jason |
| armi0024:
I need to see what's up, I may do a run of just ball tops |
| armi0024:
Bumping an old thread, we just started stocking these and they look GREAT! |
| Navigation |
| Message Index |
| Next page |
| Previous page |