| Main > Main Forum |
| Powering flourescent light in Ms. Pac Man Cabinet Conversion |
| (1/2) > >> |
| secret80sman:
Hey Everyone, I'm trying to power the original flourescent light in my cabinet. It has the original three cable connecter on the end of it. Is there a cable available that will have an AC plug on the other end or if possible a plug that I could connect to my PSU on the MAME computer? Any thoughts or suggestions would be appreciated. Thanks! |
| DillonFoulds:
Looks like no one's responded yet, what's the actual required voltage of the light? 110-120v, 100v? More? Less? I'd say figure that out, and following the wiring to find your hot, neutral and ground, and wire as necessary. If it's standard 110v, chop up an ATX (IEC-320) power cable, and wire AND INSULATE!!!! accordingly... |
| Well Fed Games:
Just bumping this, as I have the same question. I am sure someone knows, it is a pretty common cabinet! :D |
| BobA:
You can download the whole manual Basement Arcade But to summarize: The transformer that the florescent lamp is wired across is shown as the primary side of the isolation transformer 115V to 115V. It has 3 wires L N and Ground. There is no connector shown in the manual but there is a filter, ballast, starter and florescent lamp. |
| secret80sman:
What does the starter do? Does it have to be pressed when replacing bulbs? I noticed that the lamp connects via a molex connector to a wiring harness that travels down the side of the cabinet to the lower area in the back and terminates in yet another connector. I can probably take a tap there and get an identical connector and break apart an IEC cable like was suggested. Any chance I could purchase one of these premade from someone online? Thanks! |
| Navigation |
| Message Index |
| Next page |