Main > Main Forum
Alright so tomorrow is the big day i start to build >.> one last question
(1/2) > >>
darkmdbeener:
i originaly was going to put a piece of plexi or toughened glass instead of a bezel  because i was going ot have an auto rotate feature for shootem ups but that will be a while away? what should i do leave it open or add a bezel either way im going to add the auto rotate but just at a much much later date. lol outa funds XD
mgb:
You can always do a bezel now, made out of foam board or something and then just change it out for what you need when you add the rotate feature.
Or you can mask and spray the back side of the glass for a bezel and then scrape it off with a razor when you add the rotate.
using flat black spraypaint on the back side of glass really shines nicely through to the other side.
javeryh:
I'd add the bezel.  Make it look finished at least.  You can get some black matteboard for like $5 from a Michael's or A.C. Moore or some other craft store.  Just cut a hole in it for your monitor and you should be good to go.
darkmdbeener:
thank you both i actually never thought about matteboard or foam board to use atm. i will make a bezel for now and chose one of thoughs
darkmdbeener:
So i was originally going to place vinyl artwork on the board. i know that you have to sand it first and paint it. but again funds are taped atm and friends arent finished with the art yet.
the question i am getting to is can i use laminate on it and then stick the vinyl on later or would i have to strip the laminate? can i paint it and leave it painted till i get funds for the vinyl if so would just primer do or will having primer only for a long period of time hurt the cab? also from reading the forum water based is better if applying vinyl is this correct?
Navigation
Message Index
Next page

Go to full version