| Main > Main Forum |
| 25/32" T-Molding? |
| (1/1) |
| D_Harris:
I'm about to order some T-Molding for two control panels which are made out of laminated MDF. (The same material used on counter tops). With the lamination the thickness is 25/32". No one has this thickness and I was wondering if I should just get the next larger size which is 13/16" and use an Exacto blade to trim it, or should I get the next smaller size which is 3/4" and make sure I install it flush with the top of the control panels. Either way the T-Molding available will be 1/32" over or 1/32" under. Any suggestions? Thanks. Darren Harris Staten Island, New York. |
| Malenko:
bigger and trim, if you think it needs it (1/32 aint much) |
| leapinlew:
bigger and let it overhang on the bottom 1/32" |
| Nephasth:
Bigger and let it over hang 1/64" on both sides, that's practically and RCH. If need be trim the top. |
| D_Harris:
Thanks everyone. That's what I figured. Now does anyone know where I can find 13/16" green T-Molding? (I found the blue I need in that size at T-Molding.com). Thanks. Darren Harris Staten Island, New York. |
| Navigation |
| Message Index |