| Main > Main Forum |
| WIRING JOYSTICKS TOGETHER |
| (1/1) |
| Kevo!:
Hello All, I have an issue that I've been trying to workout, but seem to have a lot of trouble figuring out. I am trying to wire SANWA Joysticks with a 4 way joystick but the SANWA parts use totally different parts??? Like - I would look at wiring diagrams for linking Player 1's joystick and buttons 1 and 2 to 4way joystick and fire 1 and fire 2, and I notice that the switches used for the HAPP parts have 3 lugs - NO, NC, and Common. BUT on the SANWA buttons there are only 2 Lugs one for signal and one for ground. Also on the SANWA joysticks there are switches with no lugs and connected to a board the has 5 wires coming from it - up, down, left, right, and ground. QUESTION! - How would you wire a control Panel with... 3 Joysticks (2 being Sanwa 8-way and 1 being any brand 4-way.) 24 Push buttons - 8 action buttons per player - 3 per player buttons (start,coin,escape) - 2 fire buttons for 4-way Using an IPAC2 or.... (whatever you guys think) Sounds like a CISCO test :) ANY IDEAS!? :dunno - KEVO |
| BobA:
Simple to wire if you have 5 wires. The 4 wires go to the appropriate terminals on the ipac and the ground wire goes to the ground on the ipac. If you have a regular switch with no nc and ground then the no goes to the ipac and the gound is daisychained to the common connectors on the switch. If you only have 2 contacts on a switch one is ground and one goes to the input of the ipac. |
| Kevo!:
I understand that and sorry if my question didn't make sense to you... But what I'm looking to do is daisy chain the 4way to the 8 way SANWA as well as push buttons 1 and 2 to player one (SANWA) push buttons 1 and 2.... |
| BobA:
You can daisy chain all the switches as long as you identify the ground for the daisy chain. In the case of 2 contact switches it does not matter what is chosen as ground. |
| Navigation |
| Message Index |