| Main > Main Forum |
| Desktop Controller Help - Buy or Make? |
| (1/2) > >> |
| TNVols:
Looking for some help from the MAME Community... I am trying to figure out how much of a project to take on. I know that I don't have a ton of time to devote to getting a desktop controller up and running so I am interested in recommendations on what pre-built controller options are out there. If there are no good options can you steer me towards a fairly basic panel design that I could duplicate. Something with a track, spinner and two or three joysticks. Thanks for taking the time to read the post and give your feedback. |
| Donkbaca:
If you have a drill and circular saw, make one. A simple cp is 6 pieces of wood butt jointed together. Do you have a router? |
| TNVols:
sure do... have one that is mounted to a bench. How hard would the wiring be? |
| Donkbaca:
The wiring is super easy. Takes time, but is not at all hard. Typically you get an encoder of some sort, key-wiz, ipac, etc. you wire one end to each switch, the other end to one of the screw in terminals, then you daisy chain the grounds. |
| TNVols:
thanks for the reply... I am assuming Happ controls as the best source for controls? Also is the IPAC the encoder of choice? Thanks again for your time. |
| Navigation |
| Message Index |
| Next page |