| Main > Main Forum |
| Spinner/joystick question |
| (1/1) |
| ZERO:
I may have ordered the wrong spiner, but I'm not sure. I ordered a quad controller from north coast custom I then ordered my spiner from Ultimate arcade, it was there only one so I was thinning they where all the same. But when I tried to install it the pin does not come all the way up. Do I need to drill it? Did I buy the wrong spiner? If you need more info let me know. And about joysticks I have 4 old joysticks from an arcade, I could use them but I would have to drill the 4 bolts out. Or is there joysticks that don't require me to dill? |
| BobA:
Don't know which spinner you ordered as the site for ultimate arcade did not come up. This is the spinner that is referenced by NC Custom. Tornado |
| ZERO:
http://www.ultimarc.com/JShopServer/section.php?xSec=10 looks like i got the wrong one thanks |
| Navigation |
| Message Index |