Main > Main Forum

AimTrak firmware with recoil output

Pages: (1/1)

AndyWarne:


If anyone is experimenting with recoil, I have firmware available which outputs a 40ms pulse on pin 5 of the header when the trigger is pulled while on screen.

I think the best way of driving the solenoid is to use a mosfet. Use a 1K resistor in series with the gate. Dont forget to connect a diode across the coil to remove back-EMF.

andy@ultimarc.com

Savannan:

by any chance, would you happen to have a wiring diagram???  are you going to incorparate the solenoid into your guns and sell them?  ;D

Drakin:

I'm interested...point me to where the firmware is...Thanks Andy

Drakin

loppydog:

that would have been handy when I was setting up my Aimtraks!  But here is how I decided to do mine:


--- Code: ---http://www.electro-tech-online.com/electronic-projects-design-ideas-reviews/111309-simple-one-shot.html#post910451
--- End code ---


Pages: (1/1)

Go to full version