Main > Main Forum
Got my USB Controller from Paradise, but...
(1/4) > >>
MagicManPA:
The connectors are too small to connect to the microswitches on the joysticks. Did I fail to order them w/the right microswitch or am I going to have to rewire half of this?

Donkbaca:
what joysticks?
MagicManPA:

--- Quote from: Donkbaca on January 03, 2011, 07:42:57 pm ---what joysticks?

--- End quote ---
IL Competition.
RandyT:
The connectors on standard wire set of the Chinese XIN-MO interface (which this one appears to be) are primarily the .110" variety, which will work with the lower-end Chinese controls that were part of the pre-fab consumer control panel those interfaces were intended for.  If you measure the opening of the connector with a ruler and it's a little shy of 1/8", then those are the .110s.  The wires normally included with the XIN-MO interface are also a little too short to be comfortable on a standard sized control panel.  

We've had an offering based on these interfaces in the works  for a while, and will be adding them to the GGG line in a few days for builders where a tight budget is of higher concern than build quality.  We have already had custom wire harnesses made to address the connector size and wire length issues, as well as improved ground chain assemblies.  This added a bit to the cost, but will make the XIN-MO much more compatible with normal sized panel builds and controls.

RandyT
jipp:
i have no experience with this issue you are having.  but let paradise know whats going on.  i bought a LED stick from them to use as a dedicated 4 way ( im very happy with the quality of the stick by the way).. and there customer service was great..  send him a email or call.. im sure he will make things right.

chris.
Navigation
Message Index
Next page

Go to full version