Main > Main Forum
the state of mame
newmanfamilyvlogs:
--- Quote from: abaraba on January 13, 2011, 12:55:13 pm ---I acknowledge. I am not aiming for insults, just arrogance, so to stay in the character.
--- End quote ---
:dizzy:
Derrick Renaud:
--- Quote from: abaraba on January 13, 2011, 12:34:25 pm ---
--- Quote from: Derrick Renaud on January 13, 2011, 12:13:05 pm ---But if you read my last quote again about the 10 lines of code, take it as a challenge to code something properly. This would then get us back on topic of getting new programmers into coding MAME.
--- End quote ---
It takes 2 lines of code.
--- End quote ---
Let's see them.
--- Quote from: abaraba on January 13, 2011, 12:34:25 pm ---I can not make sense of anything else you're saying.
--- End quote ---
I can't do the reading for you. I told you to check the page you mentioned.
http://www.jstookey.com/arcade/720/720-arcadejoy.php
The current code defines the inputs as absolute. (IPT_AD_STICK_X) You need to use relative inputs.
You need to read the web page where it says: "Then in the section, "INPUT_PORTS_START( 720 )" replace: Change LETA0 and LETA1 to:"
Derrick Renaud:
I posted the steps needed to create the code for real/fake controls to coexist over in the 720 thread.
http://forum.arcadecontrols.com/index.php?topic=108516.msg1152192#msg1152192
Who wants to take the challenge?
saint:
--- Quote from: abaraba on January 13, 2011, 12:55:13 pm ---
--- Quote from: saint on January 13, 2011, 12:29:43 pm ---Tone it the hell down or get the hell off my forums.
--- saint
--- End quote ---
just arrogance, so to stay in the character.
--- End quote ---
Do not want.
ErikRuud:
--- Quote from: Derrick Renaud on January 13, 2011, 02:07:20 pm ---I posted the steps needed to create the code for real/fake controls to coexist over in the 720 thread.
http://forum.arcadecontrols.com/index.php?topic=108516.msg1152192#msg1152192
Who wants to take the challenge?
--- End quote ---
I am actually interested in it for the technical challenge even though I couldn't care less about 720. I already know how I am going to modify my spinner to incorporate the second encoder wheel.
It may be a week or so before I can begin to work on it seriously though.