Main > Main Forum

60 in 1 with trackball problem

Pages: (1/3) > >>

redfivexw:

I did quite a bit of searching on this topic and i see it is a common problem, but i am having a hard time finding the solution.  I have a "b" quality 60 in 1 icade board. I have a new Imperial trackball, and i have the connector to connect the trackball directly to the connector on the board.  However, it will not work.  I get no response at all from the trackball.  All else works fine.  Is there something i need to do to the baord/wiring/etc to make this work? 

ark_ader:

I thought 60-1 topics were taboo on this board?  ::)

redfivexw:

I was not aware of any such taboo...

BobA:

In the software dip switch setup there is a setting to switch the direction and clock signals.  You might need to set this switch to match your trackball.   There is also a software setting to switch X and Y if you need to when it is working.

I think that posting links to where the boards are sold is illegal but not discussing them.

redfivexw:

yes, the first page in the setup menu does allow to change from normal and then reverse.  i tried changing those but no difference

Pages: (1/3) > >>

Go to full version