| Main > Main Forum |
| 60 in 1 with trackball problem |
| (1/3) > >> |
| redfivexw:
I did quite a bit of searching on this topic and i see it is a common problem, but i am having a hard time finding the solution. I have a "b" quality 60 in 1 icade board. I have a new Imperial trackball, and i have the connector to connect the trackball directly to the connector on the board. However, it will not work. I get no response at all from the trackball. All else works fine. Is there something i need to do to the baord/wiring/etc to make this work? |
| ark_ader:
I thought 60-1 topics were taboo on this board? ::) |
| redfivexw:
I was not aware of any such taboo... |
| BobA:
In the software dip switch setup there is a setting to switch the direction and clock signals. You might need to set this switch to match your trackball. There is also a software setting to switch X and Y if you need to when it is working. I think that posting links to where the boards are sold is illegal but not discussing them. |
| redfivexw:
yes, the first page in the setup menu does allow to change from normal and then reverse. i tried changing those but no difference |
| Navigation |
| Message Index |
| Next page |