Just ordered a Makvision 27"/29" tri-mode flat screen CRT

[dekar24k]

Heya,

I just ordered myself a 27/29" Makvision tri-mode flat screen monitor for my new arcade project. It's analog but it will sync 15/24/31KHz horizontally which is more than what I'm asking for.

I haven't found too much info about this monitor, so I was wondering if anyone here have any experience with it?

Thanks!

[zolveria]

HERE ARE THE SPEC SHEET AND ALL OTHER INFORMATION FROM HAPP
ENJOY

http://na.suzohapp.com/service_center/makvision.htm

[dekar24k]

HERE ARE THE SPEC SHEET AND ALL OTHER INFORMATION FROM HAPP
ENJOY

http://na.suzohapp.com/service_center/makvision.htm

Thanks, but I already have the specs. I was hoping that someone out there had one of these and could share their opinion. Thanks anyways.

[grantspain]

its just a rebranded wei ya 3129/rodotron 666a
they are ok but you will get heavy scan lines on 15khz

[dekar24k]

Good thing I love scanlines. I saw some VGA screenshots of it here the other day and I think it looked awesome. Thanks for the input!

[grantspain]

some but not all have right hand side compression issues on 15khz,it's something to do with slight mismatch with the yoke
every one I have worked on/seen of these chassis has looked excellent on 31khz

[dekar24k]

Since it's not digital I was thinking of running it in 31khz only (and upscale CGA/EGA games). It works fine with most MAME games and every 8/16 bit emulator is perfectly fine at 640x480 as well. Good thing it looks good in 31khz then.

[Turambar]

What graphics card are you going to use?

[dekar24k]

What graphics card are you going to use?

I'm going to use an ArcadeVGA 3000 that I've had here for a while.