Main > Main Forum
Problems with a Mega33 Cab
Domino:
Hellows :P
I've finaly had the time to start my Mega33 Cab, sadly though all i get on startup is this
Each time I boot up, a different set of pixels is shown.
Anyone has any idea of where to start looking to solve the problem?
According to the previous owner its supposed to run Metal Slug 2.
Here's a pic of the cab itself
Thankful for any help i can get :)
bkenobi:
Looks like the board has a (or multiple I suppose) bad or badly seated rom chip. It also needs to have the tube adjusted for pincushion.
Domino:
Would that be the monitorboard or the PCB you're referring to?
Adjusting for pincushion isn't a term I'm familiar with either I'm afraid :-[
Thanks for helping out :notworthy:
//N00b on troubleshooting Arcadecabinets ::)
EDIT: Found out what pincushion ment, however that seems like a small problem compared to the "pixelissue".
Domino:
Additional info:
I was able to drill the lock today, here's what was inside. MV-1FZ Motherboard?
Any ideas what this is for?
Jumper settings, on boot the little red LED lights up, but no sound what so ever is heard from the speakers
I wasn't able to get any good shots at the monitor, but maybe these will help a little
Domino:
no one who has a single clue to where the problem might be?
Should i try to get my hands on a Jamma PCB to test?
Maybe another MVS casette?
Any ideas welcome :)