Main > Main Forum
Are Seimitsu Push Buttons NO and NC?
<< < (2/2)
saradilc:

--- Quote from: LeedsFan on October 20, 2010, 03:38:37 pm ---You could take a standard Happs push button and cut the plunger and casing down to what you need, then just glue the parts back together. For a one off button I'd be temped to give this a shot in your situation. A cherry microswitch and a cut down button with enough thread for the locking nut to grip would be about 30mm long (under the panel)

--- End quote ---

I may have to resort to this. I actually just miraculously found a local store that has momentary switches that are short enough and have NO and NC that highly resemble arcade buttons. I'm going to check it out in person and if I like what I see I will try one of those out. Unfortunately they are 24mm and not 30mm like the Seimitsu ones I ordered, however it's not a huge deal!

As for leaf buttons I'd rather avoid using one.

Another quick question: If I get a switch that has all 3: NO, NC and GND, am I able to hook up two seperate functions to the NO and NC parts of it simultaneously, or will they interfere with eachother?

Thanks for all the replies guys!
Navigation
Message Index
Previous page

Go to full version