Main > Main Forum
GP-Wiz40 MAX "KB" input
(1/2) > >>
push2reject:
What does the "KB" input do on the GP-Wiz40 MAX?  Just got mine today.  I have not yet hooked it up to a panel.  I didn't find any documentation on the GGG site on the function of this input.  Is it just a hold over from the KeyWiz Max 2.0 which has the same PCB?
push2reject:
*Bump*

Nobody?  I'm guessing the GP-Wiz is less popular than the Key-Wiz.
(I've sent RandyT a PM and an e-mail as well as making this post)
RandyT:

--- Quote from: push2reject on October 04, 2010, 06:08:23 pm --- Is it just a hold over from the KeyWiz Max 2.0 which has the same PCB?

--- End quote ---

Yep :)
push2reject:
Thanks, I figured as much.  I didn't want to test it by shorting it to ground and blowing the unit.
dholcombe:
I am somewhat confused by this PCB as well.

The documentation shows X, S!, Gnd as the last 3 pins

The PCB shows X, KB, S!. as the last 3 pins

http://www.groovygamegear.com/PDF/GP40_Eco_ST.pdf

Is the pin labeled KB on the PCB actually S! and the one labeled S! actually another ground as shown in the documentation. Basically I need to know which is actually S! and which is a 2nd Gnd pin.
Navigation
Message Index
Next page

Go to full version