Main > Main Forum

Anyone install cup holders?

Pages: << < (2/5) > >>

gryhnd:


--- Quote from: BadMouth on September 30, 2010, 04:43:07 pm ---From it's appearance, I'm not sure I'd trust it with a full pint glass. 

Have you used them with full pint glasses?  ;D

--- End quote ---

Yup, and some big ass Octoberfest type mugs as well. Those "claws" open up really wide.  They are quite sturdy. Been on there near 4-5 years now and through many parties and Superbowls :)

They are actually sold for marine purposes as well, fwiw, which is a tough enviro.

Benevolance:

We have ledges by the arcade cabinet to put glasses and food down. It's handy. But I'll usually just put my cocktail glass down on the CP itself; as long as the motion isn't too vigorous, the martini stays in the glass.

severdhed:

i put some of those flip down cup holders on my cabinet, but i hardly ever use them.  looking back, i wish i wouldnt have installed them, they look crappy on the side of my cabinet.  i will eventually remove them and fill in the holes and repaint the cabinet.

WhereEaglesDare:

http://forum.arcadecontrols.com/index.php?topic=102034.msg1080381#msg1080381

DrFrag:

I tried a few cup holder designs but decided they looked too ugly.  I ended up going with this:



Between the control panel and the screen bezel there's a flat spot about 9cm deep (3.5").  I lay down a couple of coasters there during parties.

Pages: << < (2/5) > >>

Go to full version