| Main > Main Forum |
| Anyone install cup holders? |
| << < (2/5) > >> |
| gryhnd:
--- Quote from: BadMouth on September 30, 2010, 04:43:07 pm ---From it's appearance, I'm not sure I'd trust it with a full pint glass. Have you used them with full pint glasses? ;D --- End quote --- Yup, and some big ass Octoberfest type mugs as well. Those "claws" open up really wide. They are quite sturdy. Been on there near 4-5 years now and through many parties and Superbowls :) They are actually sold for marine purposes as well, fwiw, which is a tough enviro. |
| Benevolance:
We have ledges by the arcade cabinet to put glasses and food down. It's handy. But I'll usually just put my cocktail glass down on the CP itself; as long as the motion isn't too vigorous, the martini stays in the glass. |
| severdhed:
i put some of those flip down cup holders on my cabinet, but i hardly ever use them. looking back, i wish i wouldnt have installed them, they look crappy on the side of my cabinet. i will eventually remove them and fill in the holes and repaint the cabinet. |
| WhereEaglesDare:
http://forum.arcadecontrols.com/index.php?topic=102034.msg1080381#msg1080381 |
| DrFrag:
I tried a few cup holder designs but decided they looked too ugly. I ended up going with this: Between the control panel and the screen bezel there's a flat spot about 9cm deep (3.5"). I lay down a couple of coasters there during parties. |
| Navigation |
| Message Index |
| Next page |
| Previous page |