Main > Main Forum

Need help with pc mounting

Pages: (1/2) > >>

yweiss:

Hello everyone, I want to mount my motherbored on my pc case, i see that a lot of people do it but there is a problem, all my case is full with some wired screws that i dont know how to open them, so i want to know is there is a way to open them or shuold i use just cutter and pull them out?
10x for help
there is a picture of the scrwes

jimmy2x2x:

they look like rivets to me, to remove them I would use a drill

if you do this, it might be tricky to reassemble it



yweiss:

so there isnt a way to open them?
i have to drill them and then they will fall down?

severdhed:

they are rivets, you will have to drill them out if you want to remove them. 

EwJ:

If you have a chisel you don't care much about, you can knock the heads off the rivets with a hammer and chisel and punch the rest through.  If the heads don't cut off, as long as you lift them a bit you can squish the heads with pliers until small enough to punch through.
Be careful if you try - lots of potential to hurt yourself.

Pages: (1/2) > >>

Go to full version