| Main > Main Forum |
| Need help with pc mounting |
| (1/2) > >> |
| yweiss:
Hello everyone, I want to mount my motherbored on my pc case, i see that a lot of people do it but there is a problem, all my case is full with some wired screws that i dont know how to open them, so i want to know is there is a way to open them or shuold i use just cutter and pull them out? 10x for help there is a picture of the scrwes |
| jimmy2x2x:
they look like rivets to me, to remove them I would use a drill if you do this, it might be tricky to reassemble it |
| yweiss:
so there isnt a way to open them? i have to drill them and then they will fall down? |
| severdhed:
they are rivets, you will have to drill them out if you want to remove them. |
| EwJ:
If you have a chisel you don't care much about, you can knock the heads off the rivets with a hammer and chisel and punch the rest through. If the heads don't cut off, as long as you lift them a bit you can squish the heads with pliers until small enough to punch through. Be careful if you try - lots of potential to hurt yourself. |
| Navigation |
| Message Index |
| Next page |