| Main > Main Forum |
| Help! Can not assign shift button on iPac2!?!?!? |
| (1/1) |
| ragnar:
So, my cab (see sig) is pretty much up and running. now I am trying to get the ipac2 set up. Everything is going great except that I can not assign the shift function. What I am doing: 1) Launch winIpac 2) set to table view 3) click on P1/2 shift cell 4) Upon prompting, press button that I want to have shift assigned to 5) nothing gets assigned. What am I doing wrong here? |
| ragnar:
Owe, my head. SOLVED! OK, I have to click the "shift cell" then click on the cell that represent the iPac input within the GUI with the mouse that I want to act as the shift key. I don't want to press the actual pushbutton. After re-reading the message from winIpac, I understand its meaning. |
| Nips916:
I was going to reply because I had the same issue. After staring at the screen for an hour I actually read the status which told you to click with the mouse the button you wanted to use for the shift function. I want that hour of my life back. |
| ragnar:
--- Quote from: Nips916 on September 17, 2010, 09:50:35 am ---I was going to reply because I had the same issue. After staring at the screen for an hour I actually read the status which told you to click with the mouse the button you wanted to use for the shift function. I want that hour of my life back. --- End quote --- Only half an hour of my life. I got lucky. Actually, the solution was in another thread here at byoac. I did a seearch for "ipac shift" that worked out. But i owuld have to say that hte GUI is somewhat non intuitive in regards to setting the shift key. |
| Navigation |
| Message Index |