Main > Main Forum

Help with folding steering wheel project please!

Pages: << < (5/5)

Cretster:

I got some hardwood L profile 20x20mm stuff tonight for holding the marquee.  My cold cathodes arrived too.  2 red ones and 2 white ones.
The reds are for giving a glow onto the floor out from the pedal area.

I got the pedals roughly fitted and boxed in tonight as you can see here:


The hole above is where the amp lives.  This is more or less how the cab looks at the moment:


Turnarcades:

Looking good. I would have gone with pedals over to the right and enclosed that section you reserved for the amp, but the overall cabinet is looking good - once covered over it'll look great.

Cretster:

Hmmm, that's interesting.  Presume there's a particular reason you'd have the pedals over on one side like that?sib;

Quite probable you're right about the amp but I can't be bothered changing it at this stage and I'm reasonably happy with it.
It's getting trickier now as I seem to be slowing down a bit and spending time trying to figure out what little bits & bobs need doing to ensure it ends up looking ok.

I hate prep/finish work, so this is the challenging part of the build for me....

Cretster:

Got some lights installed tonight but not a lot else done as I didn't have long.
The marquee lights are in with foil around to help spread the light out.  Seems to work ok with the rough 'test' marquee:


Not perfect but it ought to do once I print it properly.  Won't be that image, that's just a google image I borrowed for test purposes.  I'll be doing my own thing for this.  Apologies if this image belongs to someone here - will happily remove it if required.

This is how the marquee setup will look, although there is no lower trim in this pic:


Pages: << < (5/5)

Go to full version