| Main > Main Forum |
| Online Plexi, Thickness? |
| (1/3) > >> |
| dawolv:
Im ready to order the Plexi for the LCD Monitor/Bezel area. I was wondering if anyone has any good online recommendations? Im looking for a gray/smokey color, Im unsure on the thickness...Im guessing 1/4" inch? Also if any retailers would just cut it to dimensions that would be a plus, hate to spend the cash then have it break while cutting it ;) I found a nice grey shade here eStreet. Any recommendations? |
| ragnar:
I acn't believe how expensivethis stuff is. I just spent $100 at Home Depot on two sheets. The cashier said that over the past few years, prices have gone up alot. Online prices are better but with shipping, it is the same cost as Home Depot. Anyways, two questions. How much tint is there? I did not notice in your link whath the pricing was. I am doing 1/4" for everything I am doing including the monitor/bezel area. |
| dawolv:
This piece is 23.99 for a 1/4" 24"x24" sheet. About $13.00 for the FedEx shipping from that site...($36.99 total) Actually its pretty close to what I need..just need an inch removed. My verticle can be 22.5" to about 26". Not sure if I should use 1/8" or 1/4"....what are you guys using? Also anyone using 2074 Plexi? Is it too dark? Is 2064 too light? ??? |
| dawolv:
Oh hehe...found this 2064: 2074: |
| Dazz:
Seriously, I would discourage you against using plexi. You'll be replacing it within a couple years. Plexi is fairly expensive and it WILL scratch, no matter what you do to try to keep it from scratching. I strongly suggest using tempered glass with a solar gray (#16) tint. I'm not sure where you guys are but onedayglass.com is great or find a local glass shop. Odds are the glass is going to be cheaper, especially in the long run, than plexi. |
| Navigation |
| Message Index |
| Next page |