Main > Main Forum
IPAC4 and LEDs - Question about power
Suikodan:
--- Quote from: AndyWarne on September 05, 2010, 10:13:31 am ---On the 9-pin header on the I-PAC there are outputs for the 3 keyboard LEDs.
But also on the header there are 5V pins which are permanent if you just want to light LEDs all the time.
Andy
--- End quote ---
Hi Andy,
I have a token module that I want to connect to my I-Pac2 and there are 3 wires coming out of it. They're labeled Coin, Test and 5V. I understand that the Coin would go into to the appropriate slot for it but where would the two others go? I read about header but I can't visualize what it is on the board.
I guess there's also a Ground wire for it, is it ok to connect two of them in the same slot?
jimmy2x2x:
I didnt know the Ipac had keyboard LED support and a 5v line!
What are the pinouts for the header?
Thanks
BobA:
From the Ultimarc site:
HEADER PLUG AND LED WIRING DIAGRAM:
The diagram below will help if you decide to make your own LED connections. The header plug pins are shown looking from the top.
jimmy2x2x:
Thanks!
AndyWarne:
--- Quote from: Suikodan on September 08, 2010, 02:05:33 pm ---
--- Quote from: AndyWarne on September 05, 2010, 10:13:31 am ---On the 9-pin header on the I-PAC there are outputs for the 3 keyboard LEDs.
But also on the header there are 5V pins which are permanent if you just want to light LEDs all the time.
Andy
--- End quote ---
Hi Andy,
I have a token module that I want to connect to my I-Pac2 and there are 3 wires coming out of it. They're labeled Coin, Test and 5V. I understand that the Coin would go into to the appropriate slot for it but where would the two others go? I read about header but I can't visualize what it is on the board.
I guess there's also a Ground wire for it, is it ok to connect two of them in the same slot?
--- End quote ---
If you still need help with this its probbaly best to drop me an email.
Andy