| Main > Main Forum |
| IPAC4 and LEDs - Question about power |
| << < (4/5) > >> |
| Suikodan:
--- Quote from: AndyWarne on September 05, 2010, 10:13:31 am ---On the 9-pin header on the I-PAC there are outputs for the 3 keyboard LEDs. But also on the header there are 5V pins which are permanent if you just want to light LEDs all the time. Andy --- End quote --- Hi Andy, I have a token module that I want to connect to my I-Pac2 and there are 3 wires coming out of it. They're labeled Coin, Test and 5V. I understand that the Coin would go into to the appropriate slot for it but where would the two others go? I read about header but I can't visualize what it is on the board. I guess there's also a Ground wire for it, is it ok to connect two of them in the same slot? |
| jimmy2x2x:
I didnt know the Ipac had keyboard LED support and a 5v line! What are the pinouts for the header? Thanks |
| BobA:
From the Ultimarc site: HEADER PLUG AND LED WIRING DIAGRAM: The diagram below will help if you decide to make your own LED connections. The header plug pins are shown looking from the top. |
| jimmy2x2x:
Thanks! |
| AndyWarne:
--- Quote from: Suikodan on September 08, 2010, 02:05:33 pm --- --- Quote from: AndyWarne on September 05, 2010, 10:13:31 am ---On the 9-pin header on the I-PAC there are outputs for the 3 keyboard LEDs. But also on the header there are 5V pins which are permanent if you just want to light LEDs all the time. Andy --- End quote --- Hi Andy, I have a token module that I want to connect to my I-Pac2 and there are 3 wires coming out of it. They're labeled Coin, Test and 5V. I understand that the Coin would go into to the appropriate slot for it but where would the two others go? I read about header but I can't visualize what it is on the board. I guess there's also a Ground wire for it, is it ok to connect two of them in the same slot? --- End quote --- If you still need help with this its probbaly best to drop me an email. Andy |
| Navigation |
| Message Index |
| Next page |
| Previous page |