| Main > Main Forum |
| Ultimarc U360 Encoder Harness Wiring Question |
| (1/2) > >> |
| dawolv:
I just got my USB connects from Ultimarc, fast shipping from the UK to the US again :applaud: The wires on this harness look like they are 26AWG. Has anyone used the .187 QDs on these 26AWGs? If I have to use the 24-26 guage QDs wouldnt that be too small to connect to the button micro-switches? |
| severdhed:
USB connects? are you talking about the button wire harness? i don't know what guage they are for, but i used quick disconnects with the blue plastic sleeve on them, i picked them up at lowes. i just folded the end of the wire over a little and crimped them on, they have held up well. |
| dawolv:
Here is a picture of the harness: So by bending/looping/hooking the 26 gauge wire into the 16-22 gauge wire connector, you were able to use the .187 QDs for the Ultimarc USB Harness? |
| Ginsu Victim:
That's not USB. |
| ragnar:
Ya, you just have to fold the copper on top of itself 1 or 2 times. Enough that when you crimp, there is more material for the wire connector to grab onto. |
| Navigation |
| Message Index |
| Next page |