| Main > Main Forum |
| Some general quesitons about first MAME cabinet setup |
| << < (4/7) > >> |
| CheffoJeffo:
--- Quote from: cotmm68030 on September 03, 2010, 06:05:49 am ---Have you tried bypassing the JPac for the VGA? It's not required since the ArcadeVGA is already producing 15kHz. --- End quote --- The JPac isn't a scan converter and should not be bypassed. :dizzy: |
| newmanfamilyvlogs:
--- Quote from: CheffoJeffo on September 03, 2010, 06:25:02 am --- --- Quote from: cotmm68030 on September 03, 2010, 06:05:49 am ---Have you tried bypassing the JPac for the VGA? It's not required since the ArcadeVGA is already producing 15kHz. --- End quote --- The JPac isn't a scan converter and should not be bypassed. :dizzy: --- End quote --- Then I must be thoroughly confused as to what the JPAC actually does for the video signal. :( Disregard me, I suppose. |
| Malenko:
rolling you say? have you tried adjusting the Vsync and other adjstable knobs? it took a bit of tweaking for me to get soft15 running on my 25k7197 just right. cotnmm68030 the JPAC will prevent bad signals from reaching the monitor, protecting it from damage. |
| Umgar:
Adjustable knobs? Where would these be? :dizzy: Sorry, tohl noob here... |
| M.Lanza:
On the back of the monitor pcb. You can see them in the picture. |
| Navigation |
| Message Index |
| Next page |
| Previous page |