| Main > Main Forum |
| Female quick disconnects vs. soldering microswitches |
| << < (3/6) > >> |
| bkenobi:
Soldering isn't permanent (as has been mentioned), but it's certainly slower. It takes a little longer to solder in the first place, but if you need to make a single change, you have to wait for the stupid iron to heat up. Oh, and then you get to burn yourself on the wire/solder when you pull the wire out. :timebomb: Maybe that last part is just me. :cheers: |
| Ginsu Victim:
Then you accidentally touch something with the side of the iron and melt it.... |
| bkenobi:
--- Quote from: Ginsu Victim on August 30, 2010, 11:26:40 am ---Then you accidentally touch something with the side of the iron and melt it.... --- End quote --- I've done that too. :hissy: |
| MichaelA:
Thanks for all the opinions and advice, I am going to give the disconnects a try |
| Blanka:
Soldering is faster and cheaper than quick disconnects. Its easier to solder than too clamp an insulated disconnect on a cable. And they can be pretty expensive too. But the best: buy a harness for your controller. Let the Chinese do the work :D. The harness is already cheaper than cable + disconnects, and does not need any additional work too! |
| Navigation |
| Message Index |
| Next page |
| Previous page |