Main > Main Forum
Has anyone modify there cad?
gamer1942:
I had a party out side for my kids and there friends and i put my arcade machine out side(under roof) so the kids could play.I have had my machine for over 8 months and I didn't realize how much space it was taking up(so did my girlfriend).So after the party she said she didn't wanted back inside.I don't want to sell it but i think that my girl friend is rite,and i don't have where to put it other than where it was.So my question,have anyone here modify there machine to make it smaller?If so have you used the same part from your machine or started all over?
deepblue:
I'd suggest you start looking for a new girlfriend instead.
:laugh2:
jholman76:
ZING!
Or, just cut the bottom part off and make it a bartop... If you have a big enough cabinet, you will proabably have enough material. Then follow one of the many plans on the forums here to re-make it. It will be a challenge, but a fun one.
joe
Rick:
--- Quote from: jholman76 on August 16, 2010, 02:08:19 pm ---Or, just cut the bottom part off and make it a bartop...
--- End quote ---
You are talking about the cabinet, and not the girlfriend, right?
;)
deepblue:
--- Quote from: Rick Elphinstone on August 16, 2010, 02:13:24 pm ---
--- Quote from: jholman76 on August 16, 2010, 02:08:19 pm ---Or, just cut the bottom part off and make it a bartop...
--- End quote ---
You are talking about the cabinet, and not the girlfriend, right?
;)
--- End quote ---
ROFL
At least he didn't say cut off the bottom and make a cocktail.