Main > Main Forum
Happ Competition 4-way? or other Solution
<< < (8/11) > >>
Radford119:
Here are some pics of my Happ 4-way Ms. Pacman repro stick for a metal control panel mounted in a 3/4 wood panel. I chose the metal mount version because of the short throw and short height. This is a 60-in-1 jamma scratch built cab, I made it specifically to enjoy old school 4 way gaming. So far I am really enjoying the stick. The only way I think it could get better is if it was leaf based vs. microswitch. Hope this helps you out.
Ginsu Victim:

--- Quote from: mgb on August 06, 2010, 12:08:19 am ---
--- Quote from: Ginsu Victim on August 05, 2010, 09:34:29 am ---
--- Quote from: mgb on August 05, 2010, 07:48:24 am ---yeah, if you did go with a JLW, you would have to modify the mounting like from top using a pacman mounting plate.

--- End quote ---

Why?

--- End quote ---

The shafts are short.
I suppose you can also route them in under the control panel

--- End quote ---

Just confused by using a pacman mounting plate as opposed to other methods. Most people use wood panels, so the use of the pacman mounting confuses me....
EvilNuff:
Does anyone (other than you Randy:)) have a review of the GGG true 4 way?  Specifically how does it compare to the JLW?  Did not see any in the review forum?
Ginsu Victim:

--- Quote from: EvilNuff on August 06, 2010, 08:54:16 am ---Does anyone (other than you Randy:)) have a review of the GGG true 4 way?  Specifically how does it compare to the JLW?  Did not see any in the review forum?

--- End quote ---

It's brand new. He revealed it, I do believe, here first. I'm seriously considering ordering one today.

Edit: Just placed the order. Hopefully I'll have a review up sooner or later.
mgb:
The shafts are short.
I suppose you can also route them in under the control panel
[/quote]

Just confused by using a pacman mounting plate as opposed to other methods. Most people use wood panels, so the use of the pacman mounting confuses me....
[/quote]

A Pacman control panel is wood with a metal overlay. The center is cut out with a metal joystick mounting plate.
Twisted quarter sells the mounts
this setup wont work for some installs but for my cp, it works because I have a metal overlay over a wood panel.
a nice thing with this setup is also that by using spacers you have a little tweak room for setting the shaft height.
Navigation
Message Index
Next page
Previous page

Go to full version