| Main > Main Forum |
| MK2 Schematics for coin door? |
| (1/2) > >> |
| Rulkiewicz:
I recently bought a gutted MK2 cab, it came with the power supply bolted on the floor, the coin box and the marquee light. The marquee light words fine. Now I'm trying to get the light on the coin box to work... it has a connector which plugs in to something, but the board that is plugs in to is missing. There are yellow wires which connect one coin light to the other coin light, and then run down the wiring harness in to the connector. I'm thinking I need to supply power to those yellow wires...? Any ideas? |
| MonMotha:
The transformer in MK2 had a dedicated 6.3V winding for the coin door lamps. Those yellow wires should run all the way down to the transformer into a small, 2 position Molex connector (.093 pin/socket style). There is a fuse for this output separate from the 120V output that was used for everything else in the cabinet. Both fuses are installed in the metal box that the transformer is mounted to. Check them WITH A METER (a visual inspection is not always accurate). Manuals are readily available in PDF form and include a full cabinet wiring diagram. |
| Rulkiewicz:
--- Quote from: MonMotha on July 28, 2010, 11:31:20 am ---The transformer in MK2 had a dedicated 6.3V winding for the coin door lamps. Those yellow wires should run all the way down to the transformer into a small, 2 position Molex connector (.093 pin/socket style). There is a fuse for this output separate from the 120V output that was used for everything else in the cabinet. Both fuses are installed in the metal box that the transformer is mounted to. Check them WITH A METER (a visual inspection is not always accurate). Manuals are readily available in PDF form and include a full cabinet wiring diagram. --- End quote --- Could you provide a link to the pdf? |
| MonMotha:
Crazykong has it. http://www.crazykong.com/manuals/ Page 3-3 and 3-4 are the wiring info that you need. |
| Rulkiewicz:
--- Quote from: MonMotha on July 28, 2010, 12:07:40 pm ---Crazykong has it. http://www.crazykong.com/manuals/ Page 3-3 and 3-4 are the wiring info that you need. --- End quote --- Thanks. However, I do not have that 2 pin connector on 3-4. All I am left with is the 13pin connector that is connected to the coin door found on page 3-3. Is there any way I can wire power to the yellow and yellow/white wires? |
| Navigation |
| Message Index |
| Next page |