Main > Main Forum
beginner needing help converting Jamma to MAME.
<< < (2/3) > >>
Turnarcades:

--- Quote from: CheffoJeffo on July 14, 2010, 10:22:25 am ---First question (and I know you wanted an answer, not a question) is how is the Megalo wired ?

If JAMMA, then, yeah, I would would start with a JPac and ArcadeVGA.

--- End quote ---

No way cheff, I fully expected a 'read the wiki' quote there!
CheffoJeffo:

--- Quote from: Turnarcades on July 14, 2010, 08:15:50 pm ---No way cheff, I fully expected a 'read the wiki' quote there!

--- End quote ---

I'm getting old ... nice to see you again sir!
Turnarcades:
Been busy - we're expanding at the mo, bit like my waistline unfortunately!
dfg:

--- Quote from: Malenko on July 14, 2010, 03:02:21 pm ---if its JAMMA, you plug the JPAC into the jamma connector, then from the JPAC run the 2 wires to the PC (VGA and either USB or PS2)  You'll still need either an ArcadeVGA or Soft15 to feed the monitor the appropriate signal. The JPAC has screw terminals on it for the extra buttons for players 1 and 2, you just need to run wires to the microswitches.

--- End quote ---

Pretty straight forward i see.
how about the power source? is it combined? or just separate outages for the "cab" and "pc" ?
dfg:

--- Quote from: BobA on July 14, 2010, 04:02:43 pm ---Check which monitor you get.   The original could do 3 resolutions.  If that is the monitor the highest res can be supported without the aracdevga.  However the arcadevga will give you the authentic resolutions that can also be shown on your monitor.

--- End quote ---

well this is the original cab. - Can take all pcb games for 15k/24k/31k use
so would this mean i can use my current 8500gt card? or id still need to purchase a ArcadeVGA 3000 ?
Navigation
Message Index
Next page
Previous page

Go to full version